Starting A New Job (Or Refilling The Cup); Reversible Tip Selection Chart - Graco 16F887 Operation Manual

Starting a New Job (or Refilling the Cup)

Starting a New Job
(or Refilling the Cup)
When spraying flammable or combustible materials:
• Remove entire sprayer from hazardous location
when refilling.
• Always ground the material cup when refilling.
• Keep material containers covered between cup
refills.
1. Engage trigger lock and put prime/pressure relief valve
UP to release pressure.
ti16699a
ti14994a
2. Install material cup liner, fill with material, and
thread onto sprayer.
3. To prime pump, disengage trigger lock and trigger
sprayer for 10 seconds. Then release trigger and
put prime/relief valve DOWN to spray position.
ti16698a
ti14995a
14
ti16700a
ti14999a
ti15474a
ti16715a
ti16716a
ti15418a
4. Reverse spray tip to UNCLOG position and spray
into waste area for five seconds.
ti14991a
ti14991a
5. Put prime/pressure relief valve UP to release pres-
sure. Then rotate tip back to spray position.
NOTE: Failure to perform this operation could result
in poor spray pattern.
ti16700a
NOTE: If sprayer fails to prime, follow Alternate
Priming Method (page 24).

Reversible Tip Selection Chart

Fine Finish Materials and Tip Sizes
Fan
Width
4 in.
(10 cm)
6 in.
(15 cm)
8 in.
(20 cm)
Use with all fine finish materials including "hot" solvents.
ti15425a
ti16701a
ti15491a
THIN MEDIUM
Stains Lacquers,
Clears
208 210
308 310
410
ti14985a
ti16713a
ti16992a
HEAVY
Enamels
312
412
3A1698G