Unclogging Spray Tip/Guard Assembly - Graco 258850 Operation Manual

Unclogging Spray Tip/Guard Assembly

Unclogging Spray
Tip/Guard Assembly
Do not operate or spray near children. Do not aim the
sprayer at, or spray any person or animal. Keep hands
and other body parts away from the discharge. For
example, do not try to stop leaks with any part of the
body.
Occasionally, debris from material can accumulate and
clog the spray tip. Perform the following steps to unclog
the tip.
1. To unclog tip obstruction, engage trigger lock and
pull relief valve UP to release pressure.
ti14994a
2. Reverse spray tip to UNCLOG position.
3. Aim sprayer at waste area, disengage trigger lock,
and put prime/relief valve DOWN to spray position.
Pull trigger to clear clog.
ti14995a
4. Engage trigger lock. Put prime/relief valve UP to
release pressure and rotate spray tip back to
SPRAY position.
ti14994a
3A1204E
ti14999a
ti15425a
ti14999a
5. Disengage trigger lock, put prime/relief valve DOWN
to spray position, and resume spraying.
ti14995a
6. If tip is still clogged, you may have to repeat steps
1 - 5 and rotate the tip from SPRAY to UNCLOG
several times. Repeat step 1 to release pressure,
remove and clean filter, or replace with new tip
assembly.
ti14989a
NOTE: Filter assembly is reverse-threaded:
Turn left (or counter-clockwise) to install.
Turn right (or clockwise) to remove.
7. If obstruction is cleared, engage trigger lock and
rotate arrow-shaped handle back to SPRAY
position.
ti14994a
ti15425a
ti14985a
13