Battery And Charger; Battery Disposal; Charging The Battery - Graco 16F887 Operation Manual

Battery and Charger

Battery and Charger
• Lithium Battery Packs: Batteries are low mainte-
nance. They can be used at any charge level with-
out creating a memory effect.
• Battery Protection Features: Battery is designed
with protection features to maximize battery life. If
sprayer stops during operation refer to the sprayer
and battery indicator lights to determine proper
action.
• Battery Run Time: To maximize battery run time,
spray with; lower pressure. larger tips, thicker mate-
rials, and at cooler temperatures.
• Charging a Hot or Cold Battery: The battery may
be immediately placed into the charger. Charging
will not start until battery temperature is within the
allowed temperature range. Charging will begin
automatically when the battery is within the allowed
temperature range.

Battery Disposal

Do not place batteries in the trash. To find a recycling location in the USA and Canada call 1-800-822-8837 or go to
www.call2recyle.org.

Charging the Battery

Replace and charge battery only in a well-ventilated area
and away from flammable or combustible materials,
including paints and solvents.
8
• Cold Weather Battery Operation: Batteries may
be used in cold temperatures. However, if sprayer
light indicates battery is too cold, you may warm the
battery by operating the sprayer in prime mode with
water for a minute. Once battery warms to operating
temperature, sprayer will operate normally
• Battery Storage: To maximize battery life between
uses, store batteries with a full charge in tempera-
tures between 32 – 70° F (0 – 22° C) in a low humid-
ity environment. Store batteries at full charge.
• Battery Replacement: If a battery has been fully
charged and will not spray more than one cup of
material or the sprayer will not run, the battery
needs to be replaced.
Batteries are partially charged to provide optimum battery
life and require charging before first use. It takes approxi-
mately 45 minutes to charge a dead battery to 80%, at
which point it can be used. It will take approximately 75
minutes to fully charge a dead battery.
1. Place charger in a dry, well-ventilated area and away
from flammable or combustible materials, including
paints and solvents.
ti25930a
3A1698G