Ablerex 525VA User Manual

SAVE THESE INSTRUCTIONS

This Manual Contains Important Instructions that should be Followed during Installation and
Maintenance of the UPS and Batteries.
CAUTION-
◆Intended for Installation in a Controlled Environment.
◆Maximum ambient temperature 35°C.
◆Servicing of batteries should be performed or supervised by personnel
knowledgeable of batteries and the required precautions. Keep unauthorized
personnel away from battery.
1 Inspection
Inspect the UPS upon receipt. Notify the carrier
and dealer if there is damage. The package is
recyclable; save it for reuse or dispose of it
properly.
2 Placement
5 Connect telephone /
Network Surge
protection
Provide RJ11/RJ45 connector to extend the
connection of telecommunication/ network cable.
USER'S MANUAL
IMPORTANT SAFETY INSTRUCTIONS
3 Check the Site Wiring
Fault Indicator
Caution: If the site wiring fault indicator lights,
get a qualified electrician to correct the building
wiring.
6 Connect Computer
Interface Port
Connect the optional interface cable to the USB
interface port on the back of the UPS. Connect
to the computer. See software document for
installation instruction.
525VA/625VA
SETUP

4 Connect the loads

First, connect the UPS with the AC Mains, then plug the
loads into the output connectors on the rear of the UPS.
To use the UPS as a master "On/Off" switch, make sure
that all of the loads are switch "On".
Caution: Do not connect a laser printer to the outlets.
These UPS outlets provide battery power to the
equipment when utility voltage is outside acceptable
limits.

7 Operation Test

1. Connect the UPS to the wall receptacle.
2. Push on the Main Switch to check the Green Line
( ) LED is on.
3. Connect your computer equipment with sockets of the
UPS and pull off the input power cable of the UPS
from the wall receptacle to check if the Line (
is flashing every 3 seconds. Meanwhile, please check
if alarm buzzer is beeping.
4. Try the field working condition by running some
application programs on your computer and repeating
step.
5. Check if the UPS is initiated properly to support
continuous operation.
IMPORTANT NOTICE:
6.
wall outlet to charge the UPS for over 8 hours before
using the UPS.
STORAGE:
7.
Store at -15 to +30 °C (+5 to +86 °F), charge the UPS
battery every six months.
Store at +30 to +45 °C (+86 to +113 °F), charge the
UPS battery every three months.
192321932018001
) LED
Plug the UPS into the