Table of Contents
Advertisement
INSTALLATION
& SETUP
Step 33
Step 34
2.9
Source Setup
Step 1
Note: On all models, it may be necessary to readjust the lens' rear wing nut to
keep the center defocused.
Rotate the blue lens using the rear wing nut until the picture is focused in the
center. Tighten the rear wing nut.
If necessary, loosen the front wing nut, rotate the front lens barrel to readjust
the focus in the comers, then re-tighten the wing nut. See Step 15.
For the 8500LC/9500LC, optical alignment is now complete. If you had
removed the foam insert, reinstall it now. Install the front top cover. Proceed
to set up each source by following the source setup procedure in section 2.9,
Source Setup.
On the 8500, tighten the bolts labeled "A". Optical alignment
is now complete. If you had removed the foam insert,
reinstall it now. Install the front top cover. Proceed to set up
each source by following the source setup procedure in
BGR
section 2.9, Source
Setup.
This section gives step-by-step instructions for quick setup of the projector for
a selected external source. For a complete setup, repeat these steps as required
for each source connected to the projector.
Before starting, ensure that the projector is optically and mechanically aligned.
If optical alignment is required, follow the setup instructions in section 2.8,
Optical Alignment.
Select the source to be set up using the Source command
and make sure it is visible on the projection screen.
To make setup easier, it is
m-
recornmended that you use the
v
projector's Guided Source Setup
'mtorial. It provides source setup
1.
2.
instructions on screen to guide you
3.
through the adjustments. To access
4.
the
tutorial,
first press ~
at
5.
6.
presentation level. The Help menu is
Guided
Source
Setup
Guided
Mechanical
Setup
Source
Selection
Guide
Keypad
Guide
Using
Help
displayed. Next press a to select
Guided Source Setup. The first page
I
For
all menus:
Press
a
number
or use 4Q
then
<ENTER>
to
select- f~~m-
of the guide will be displayed on the
I
<HELP>
for
assistance-
--
.
projec~on screen. Wh~n using the
I
<RECALL>
to go back
one
level
<EXIT>
to
return
to picture
guide, press @
to display the next
page, press -
to display the
previous page. When complete, press @@.
Press @@ then ~ or m to increase or decrease the brightness setting until
black areas in the image just disappear.
2-24
..
..
Advertisement
Table of Contents
