Table of Contents
Advertisement
INSTALLATION
& SETUP
Step 70
Step
71
Step 12
Step 13
Step 14
2.10
Memory
Setup
Adjust C linearity as follows:
Press D or@ until the horizontal line through the
,'
\
center of the crosshatch is equally distant from the
lines at the very top and bottom.
J
Before
After
Press Ill or@ until the center of the crosshatch is
f
\
\
equally distant from the vertical lines at the left and
+
right edges.
\
,
J
L
&
J
Before
After
Adjust S linearity as follows:
Press B or lZl until the height of each crosshatch
square is equal from the top to the bottom.
m+m
Before
After
Press a or@ until the width of each crosshatch
square is equal from the left to the right.
The source connected to the currently selected input should now be visible. If
there is no picture, check to see if the source is active.
Press El, ~, ~ or Ill to adjust phase until the
picture is centered on the screen.
a"~
After
Press ~,
, m or m to adjust the size of the
picture. Ensure that objects in your picture have the
correct shape. For example, if there is a circle in
[n]"[n]
your picture, size should 'be adjusted until the circle
Before
is round, not oval.
The final step is convergence. If the projector
includes the ACON option, press ~
=
u to
m -+
exit the guide and alIow ACON to converge the
system. Otherwise, press (ml 1~1 ~1 to enter
Before
Guided Convergence.
After
a
After
Reminder:
Remember
that all of the adjustments above should be repeated for
other sources in the system.
This section explains how to set up projector memories to improve the
performance of the projector's ASI and ASR features. If you are not farniIiar
with setup memories, read section 3,
Operation,
prior to memory setup; in
particular, read section 3.4,
Setup Memories,
and the
ASI with Save
and
Turn
ASR OnlOff
entries in section 3.7,
Utility Features.
If the projector's setup
memories are properly set up, the projector will be easier to use and operate.
2-26
.
..—
-.
Advertisement
Table of Contents
