Table of Contents
Advertisement
OPERATION
Program a channel as follows:
When the Channel List is first
displayed, the cursor is
positioned in the channel
number column. While in the
channel number column, press
or@ to highlight the
channel you want.
Alternatively, you can
highlight the channel you want
by entering the channel
number on the keypad.
lmml~
CH
NAME
INPUT
RECALL
U/D
01
COMPUTER
A
02
04
02
COMPUTER
8
14
01
03
VCR
12
4
04
VGA
23
/
05
VGA
MODE
2
23
06
07
08
09
10
(2 digit
no. > or ~~
to select
channel
O
to edit
selected
channel
Entering the channel number also allows you to select/display/edit channels
beyond the fiist ten.
Next, press E to move the cursor to the Name field. While in
"
the Name column, El and IXlchange the character at the cursor
t
position and @ and E move the position of the cursor. Once a
t
source name has been entered, move the cursor to the Input field
i@
by pressing =
or by using E. Edit the Input, Recall, and
space
9
m
Up/Down (U/D) fields. See below for field definitions. To exit
~
the channel list, press (=1
or m.
.
1
Note: When the cursor is positioned
on a edit field, the jield may
"
be cleared by pressing Q
NOTE:
If a channel is selected and ASR is on for the same input, and the
incoming frequency does not match the selected setup memories frequency, it
may cause the following: ASR may be triggered, the setup memory may
change and the channel number may be changed to reflect the new memory.
Example: If Channel 4 shows input (1,3) and no recall number and input (1,3)
switcher 1 slot 3 is selected and recall memory 55 is currently selected then
the Source Message box will show that Channel 4 is selected unless there is
another channel with input (1,3) and recall 55
The Name Field
The Name field stores the names of the sources in the list. Source names may
be up to 11 characters in length. It is recommended that source names be
entered to make it easier to keep track of the sources. Source names are
briefly displayed when channels are selected.
Notes: 1) Digits may be entered using the number keys on the keypad or
selected using the 8 and @ keys. 2) If El is pressed during name editing, all
characters
in the field to the right of the cursor will be cleared.
3-37
. . ....... ..
\
. .
Advertisement
Table of Contents
