Table of Contents
Advertisement
OPERATION
Remote Jack
EEIEIE
II
ClocWEvents
This setting determines how the projector responds to devices connected to the
REMOTE jack on the projector's rear panel. This jack can accept input from
a wired keypad or remote IR sensor. Four settings are available: A or B, A,
B, and Off. If set to A, the projector will only respond if the keypad using the
REMOTE jack is set for protocol A operation. If set to B, the projector will
only respond if the keypad using the REMOTE jack is set for protocol B
operation. If set to "A or B", the projector will respond to both protocol
settings for keypads using the REMOTE jack. If set to Off, the REMOTE
jack is disabled.
Communication
Setup
Press a from the Remote Control Options menu to set
m@Q~
the projector identification number and the RS-232
serial port baud rate.
m
I
<no. >
to change
Projector
I
This item contains the projector's identification number. The projector's
identification number allows IR remote control of a single projector in a multi-
projector installation. To set the projector identification number, select item 1
then enter a three digit number from 000 to 999. If there is only one projector
in the installation, 000 is the recommended projector number. For more
information about multi-projector control, refer to section 3.8,
Multi-projector
Functions.
Baud Rate
This
item contains the projector's RS-232 serial port baud rate, The RS-232
serial port, located at the back of the projector, provides a means to control the
projector using a computer or another projector. The serial port baud rate
setting must match the operating baud rate of the controlling device. Baud
rate may be set to 300, 600, 1200, 2400, 4800, or 9600. To set the baud rate,
select item 2 from the menu until the desired baud rate is displayed.
Notes: 1) If unsure of your computer's
baud rate setting, refer to the system
documentation
provided with the computer.
2) For information
about cable
connections
between devices, refer to Appendix D.
Clock/Events allows you to set the projector's real-time clock/calender and
program up to twelve individual projector control events to be automatically
executed at specified times or intervals.
To select the Clock/Events menu, press ~ from
ma>
the Utilities menu. Two selection items are
available: Set Clock and Promunmable Events.
The current time and date se~ting is displayed at
I
1.
Set
Clock
the bottom of the menu.
2.
Programmable
Events
I
Time:
12:34
p.m.
Date:
09/29/95
3-42
.
Advertisement
Table of Contents
