Table of Contents
Advertisement
I
OPERATION
~
To select an input:
Press (-l
1~)~ at presentation level.
where: m = O (projector) or 1-9 (switcher 1, 2, ... 9)
n = 1-9 (slot number)
The projector switches to, and displays, the source connected to the input
selected. The projector ako uses the display settings previously set in memory
for that input. If the selected input is invalid, a warning message is displayed.
An example of an invalid input might be "O 1" when a switcher is connected
to slot 1 of the projector. Another example of an invalid input would be to
select a switcher which does not physically exist.
Example 1
Slot 1 on the projector has the output from a computer workstation connected
to it. To display the workstation output, press L-l
n a.
II
m-
INPUT
The
workstation output
SOURCE
is connected
to
slot 1 of the projector.
Example 2
A single Marquee signal switcher is connected to the projector and a computer
is connected to slot 3 of the switcher. To display the
computer
output,
press
-----
EZEI!ZI
13.
-.
7
El
d
SOURCE
~
Switcher Number 1
~
INPUT
The computer output
is connected
to slot 3
of switcher number 1.
Note: If a switcher is connected to the projector,
using the switcher's front panel push buttons.
The switcher output
is connected
to
slot 1 of the projector.
its inputs can be selected
3-11
. .
Advertisement
Table of Contents
