Electrohome Marquee Ultra Series User Manual page 14

I
HWTALLATION
& SETUP
If the keypad is configured for IR remote operation, make sure the batteries are
installed. If it is configured for built-in or wired remote operation, make sure
its extension cable is properly connected to the projector. Perform the
following keystroke sequences to change its operating settings:
" To toggle the keypad's protocol setting (A or B),
press W [~1 1~1 = U.
s To toggle the backlit feature (enable or disable),
press @ [-l [~ IZ@El~.
" To return all configuration settings to the jumper settings,
press ~ [~1 1~1 = (Z1.
Note: The projector will not respond to keypad commands if you press
Qmmm@.
If pressed accidentally, press @ m ~ = to
clear all keystroke settings.
Reverse Scan
If the projector is not installed in a front screen, floor mount configuration,
reverse scan setup may be required. Reverse scan setup must be performed by
a qualified Electrohome service technician. Refer to Table 2-2 to determine if
reverse scan setup is required. Contact your dealer for assistance.
Table 2-2. Operating Configurations
OPERATINGCONFIGURATION
HORIZONTAL
VERTICAL
SCAN SCAN
Front Screen,
~~
Floor Mount
NORMAL NORMAL
(default configuration)
Front Screen,
~w
Ceiling Mount
REVERSED REVERSED
Rear Screen,
kh
Floor Mount
REVERSED NORMAL
Rear Screen,
~v
Ceiling Mount
NORMAL
REVERSED
Rear Screen,
I%P
Floor Mount, NORMAL
NORMAL
With Mirror
2-10
-. ......