Source Connections - Electrohome VistaGRAPHX 2500 User Manual

2.4 Source
Connections
The table or cart should be reasonably level. Fine adjustments to the projector
level can be made by adjusting the height of the projector legs; refer to 2.7,
Leveling for details.
Note that VistaGRAPHX 2500 can be rotated and mounted at any vertical angle-
i.e., you can tilt the projector forwards or backwards as much as desired for your
application. The side-to-side tilt, however must not exceed 45° (see Figure 2-7).
This limit ensures that the arc lamp in the projector operates properly and safely.
Figure 2-7. Vertical and Horizontal Tilt Ranges
If the projector is to be inverted, a ceiling mount fixture is required. Electrohome
provides a ceiling mount kit for assembly and installation by a dealer/installer.
For more information, contact your dealer or Electrohome.

In rear screen applications where space behind
the projector is limited, a mirror may be used
to fold the optical path. See Figure 2-8. The
position of the projector and mirror must be
accurately set. If considering this type of
installation, call your dealer for assistance.
The rear panel of the projector has two standard input panels to which you may
connect a variety of sources. The upper right panel (DAT 1) accepts an RGB
input from an external RGB source with audio follow-through. The lower left
panel (if video decoder module is installed) accepts composite video (VID 1) or
S-video (VID 2) and audio from devices such as video tape or disk players.
There are also several optional interfaces available for connecting other sources
(DAT 2). Such an option installs in the upper left panel. See Figure 2-9.
INSTALLATION & SETUP
Figure 2-8. Folded Optics
8EIJ=/4)20: #
User's Manual
2-9