Table of Contents
Advertisement
Section
2
Installation & Setup
This section explains how to install and set up the projector.
If you are familiar with the projector and want
to quickly set it up for temporary use, follow the Quick Setup instructions in section 2.1. For a complete
setup, skip section 2.1 and follow the instructions and guides covered in the remaining subsections.
2.1
Quick Setup
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Follow these 7 steps for quick set up of the projector:
Position
the Projector
To perform a quick setup, the projector must be positioned so that the throw
distance is the same as that used during the most recent optical alignment;
otherwise a detailed setup is required . The throw distance is the distance
between the center lens on the projector and the center of the projection
screen. See Appendix F and Appendix G for more information.
Note: If an
optical lens alignment
is required, refer to section 2.8, Optical Alignment.
Connect
the Power Cord
Plug the AC line cord into the line input unit on the lower front panel of the
projector. Plug the three prong end of the line cord in a grounded AC outlet.
Notes: 1) Input voltage must be between 90 VAC and 264 VAC. 2) Ensure the
line cord is the proper type for the AC receptacle.
Connect a Source
Connect a source to the projector's built-in RGB input (slot 1) or, for the
9500LC Ultra, the Image Shifter RGB input (slot 2). Ensure the source is on
and properly connected.
Access
the Keypad
Remove the projector's front top cover to access the keypad. See page 3-2.
Turn the Projector
On
Press -
on the keypad to turn the projector on. Hold down the power key
for about one second.
Note: If the keypad has been configured for IR remote
operation, point it towards the screen or the front of the projector.
Select the Input
Press [=1
!Zl~ to select the source connected to the built-in RGB input or,
if a 9500LC Ultra,
press
[~1
IF] @
to select the source connected to the
Image Shifter input.
Adjust the Display
Press [~1 [~1to select the Guided Source Setup tutorial.
2-1
. ...
I
"-""
Advertisement
Table of Contents
