Table of Contents
Advertisement
OPERATION
between "the two closest" setup memories. This feature is very usefid when
adding a new source to the system ardor when much adjustment is required.
By using the "ASI with Save" feature, the projector can do most of the
required adjustments for you.
~
To perform an "ASI with Save", press @lfrom the
Source Setup menu. A dialog box is displayed.
m
AS I
WITH
SAVE
Press
@
to move the cursor bar to "Do It" then press
-.
New display settings will immediately be
Warning!
Current
setup
wil
be lost.
calculated and saved in the current setup memory. The
DO
It
.
only exception is when the current setup memory is
locked. If locked, display settings will not be modified. If "Cancel" is
selected from the dialog box, the operation is stopped. For more information
about the ASI logic process, refer to Appendix C,
ASRIASI Logic Diagrams.
Notes about the ASI feature ...
ASI works better when there are many setup memories in the system. For
example, if you always use the same input and you never use Recall memories
(thus only one setup memory has ever been created), ASI will not be effective.
However, if many Input and Recall memories have been used and adjusted for
a variety of sources, the projector has more "knowledge" in its database for
performing an ASI. As this "knowledge" increases, ASI accuracy improves.
ELla!zl
Current Setup (LockecYUnlocked)
This utility allows you to lock or unlock the current setup memory. Locking a
setup memory prevents changes to display settings from being saved in that
memory. For example, if a locked Recall memory is selected and then
brightness is adjusted, the new brightness setting is only temporary. If the
Recall memory is reselected, the original brightness setting will be restored.
Note: When a locked setup memory is selected, a key icon ( _
) is
displayed
in the Source Message.
~
To lock or unlock the current setup memory, press E from the Source Setup
menu. Item 3 in the menu indicates the current setting.
EEIEIEI
ASR (On/Off)
The ASR (Automatic Source Recall) feature provides automatic Recall
memory selection or ASI (Automatic Source Interpolation) for inputs which
have ASR set to On.
~
To turn ASR on or off for the current input, press a from the Source Setup
menu. Item 4 in the menu indicates the current setting.
When ASR is on, the projector monitors the current input for horizontal and
vertical scan frequency changes. When a frequency change occurs, the current
Input memory and all Recall memories are scanned in search of a memory
with matching scan frequencies. If one exists, this memory becomes the
current setup memory. If a matching memory is not found, an ASI is
performed. ASI automatically adjusts display settings based on the settings of
3-33
-. .... . ..—
.
Advertisement
Table of Contents
