Cleaning - Electrohome Marquee Ultra Series User Manual

I
MAINT_ENANCE
Ventilation Slots
Servicing
ACON
m
e
4.2 Cleaning
Lens Cleaning
Operate the projector at the voltage indicated on the line voltage indicator. Do
not overload power outlets and extension cords as this can result in fire or
shock hazards.
The projector is equipped with a three wire plug having a third (grounding)
pin.
This is a safety feature.
If you are unable to insert the plug into the
outlet, contact an electrician to have the outlet replaced. Do not defeat the
safety purpose of the grounding-type plug.
Slots and openings in the projector provide ventilation. To ensure reliable
operation of the projector and to prevent overheating, these openings must
never be blocked or covered. The projector should never be placed near or
over a radiator or heat register. The projector should not be placed in an
enclosure unless proper ventilation is provided.
Do not push objects of any kind into the projector through the ventilation
openings. They may touch dangerous voltages or short-out parts resulting in a
fire or shock hazard. Do not spill liquids of any kind into the projector.
Should an accidental spill occur, immediately unplug the projector and have it
serviced by a qualified service technician.
If any of the following conditions exist, unplug the projector from the power
outlet and refer service to qualified service personnel.
The power cord has been damaged.
Liquid has been spilled into the projector.
The projector has been exposed to excessive moisture.
The projector does not operate normally.
The projector has been dropped or the case has been damaged.
Projector performance has deteriorated.
Do not attempt to service the projector yourself. All servicing must be
performed by a qualified Electrohome service technician. If replacement parts
are required, it is important that only Electrohome approved parts are used.
Other parts may result in fire, electric shock or risk of personal injury.
WARNING: THE PROJECTOR IS INTERNALLY SHIELDED TO
PROTECT THE USER FROM EXPOSURE TO SOFT X-RAY
w
RADIATION. IMPROPER SERVICING OR SHIELD REMOVAL MAY ~"~
RESULT IN PERSONAL INJURY.
In rare instances, flashing lights can trigger an epileptic seizure. During
ACON usage persons with epilepsy should look away from the screen.
Clean the projector when required. Before cleaning, always unplug the
projector from the power outlet.
To avoid the risk of scratching the lenses, only clean the lenses if absolutely
required. A small amount of dust on the lenses will have very little effect on
picture quality. If the lenses must be cleaned, use a DRY soft cotton cloth.
Rub gently in a circular motion.
4-2
-..