Power Supply / Power Failure / Batteries; Safety Information - Aastra 142d User Manual

Using the Aastra 142d Telephone

Power Supply / Power Failure / Batteries

This product requires a 100V to 240V alternating current power supply for oper-
ating the charging station. When you wish to disconnect the charging station from
the power supply, pull the power supply unit plug out of the mains socket.
If there is a power outage, all memory data (programme and user data) are saved
on the mobile unit without alteration.
Please refer to page 86 for important information on battery use.

Safety Information

The charging station may only be set up and operated within a closed building.
Place the charging station on an anti-slip mat.
Do not set up the charging station and mobile unit near:
■
water, moisture or damp places
■
heat sources, direct sunlight or unventilated places
■
devices which generate powerful magnetic fields
■
places where the device can be covered up or liquid can get in
■
dusty places and places subject to vibrations, shocks or extreme temperature
fluctuations.
Please be sure to note the following when setting up, connecting and operating
the telephone:
■
Position the connecting cable where it will not cause an accident!
■
Be sure to only connect the connecting cable into appropriate sockets.
■
Connect only approved accessories.
■
Use the supplied AC adapter (ID No.: 23-001071-00) only.
■
Do not use any power supply that is visibly damaged (ruptures, housing
cracks).
■
Research has demonstrated that in certain cases medical devices can be
affected by portable telephones (DECT) that are switched on. This is why when
within medical institutions you should be sure to comply with the regulations
of the respective institution when using portable telephones.
■
Do not hold the telephone in the hands-free mode next to your ear as the
volume can be very high.
2