Activating Charging Station - Aastra 142d User Manual

Installation
For understandable reasons, the manufacturer cannot assume liability for these
types of damage. This is why you should use an anti-slip mat under your charging
station – particularly with furniture that is new or has been freshened up with
lacquer care products.
Note:
Please make sure you do not set up the charging station in the space where
doors or windows open: Damage Risk!

Activating Charging Station

Safety precaution
Only use the AC adapter with the ID No.: 23-001071-00 type designation as
intended for the charging station!
The power supply unit is suitable for 100V to 240V alternating current (50 - 60 Hz).
It comes with 4 interchangeable adapters so it can be used practically anywhere
worldwide. As needed, put the connector onto the power supply used in your
country.
Power Supply
Note:
If the AC adapter is not connected or there is a power failure your charging
station is not operable. A mobile unit on the charging station which is not
connected to the mains socket remains switched on and discharges during the
stand-by time.
8
Position the switch on the power supply at OPEN and slide
the connector in place upwards and off. Stick the desired
new connector into the power supply and push it down-
wards until it clicks into place.
Insert the power cable into the socket on the charging
station and then the AC adapter into a mains socket.