Yeti Cycles ASX '07 Owner's Manual page 14

Assembly Cont.
frame assembly lube the Main pivot pin (M6 X 17 X 67.5 mm) with
17
a lithium or ploylube grease.
frame assembly slide the swingarm into position over the main
18
pivot mount above the bottom bracket. line up the inner race of the
bearing with the thru hole on the main pivot.
slide the Main pivot pin (M6 X 17 X 67.5 mm) into the bearing and tap
through the frame with a dead blow hammer. there may be some
resistance as you tap the pin through, this is normal. tap the pin until it sits
flush against the bearing face,
frame assembly slide the Main pivot Washer onto the Button Head
19
Bolt (M6 X 1 X 12 mm). apply a small amount of blue loctite to the
threads and thread into the Main pivot pin.
frame assembly place a 5mm allen key on the Button Head bolt
20
and a 6mm allen key into the main pivot pin and secure.
torque spec: 125-150 inch pounds.
assembly 28
frame assembly rotate the swingarm into position over the end
21
of the shortlink. slide the Guide pin through the seatstay mount as
shown.
slide the Washer (8.5 X 12.5 X 0.5 mm) onto the Female Yeti Bolt 43mm.
then attach the bolt and washer to the stepped end of the Guide pin.
frame assembly tap the end of the bolt with a dead blow hammer
22
to slide the bolt through the seatstay mount and shortlink.
frame assembly attache the
Male pivot Bolt 17mm and
23
X 12.5 X 0.5 mm) onto the female bolt. Make sure to apply a small
amount of blue loctite to the threads.
torque spec: 125-150 inch pounds.
frame assembly the last step is to attach the derailleur hanger.
24
place a small amount of blue loctite on the threads of the derailleur
hanger bolts and secure with a 2.5mm allen key.
Washer (8.5