Yeti Cycles ASX '07 Owner's Manual page 13

Assembly Cont.
linkaGe assembly Use two 5mm allen keys to secure the Button
9
Head Bolts (M6 X 1 X 12 mm).
torque spec: 125-150 inch pounds.
linkaGe assembly tighten the socket Cap (M4 X 16 mm) pinch
10
bolts on the shorlink with a 3mm allen key to finish the linkage
assembly. this step will secure the bearings and make sure the linkage
assembly does not shift under load.
torque spec: 40-50 inch pounds.
frame assembly slide the black inner Bushing into the iGUs
11
Bushing on the top end of the Dogbone.
frame assembly orient the shock into the proper position on the
12
bike. slide the head of the shock in the frame tabs as shown. line up
the thru holes on the frame tabs and the shock eyelet. slide the Female
Yeti Bolt 24.8mm and Washer (8.5 X 12.5 X 0.5 mm) through the frame and
shock
assembly 26
chanGes We strive to make the best bikes in the world,
because of this dedication to be the best, we continually make
changes to our bikes as needed. as the bikes are improved,
assembly and setup instructions may be affected. any
amendments to the existing owners Manual can be found on
our website. www.yeticycles.com
frame assembly swing the Dogbone up to the preferred travel
13
position and lineup the thru holes on the frame and Dogbone. slide
the Female Yeti Bolt 24.8mm and Washer (8.5 X 12.5 X 0.5 mm) through the
frame and shock
frame assembly thread the Male pivot Bolt 17mm and Washer
14
(8.5 X 12.5 X 0.5 mm) into the female bolt. Make sure to apply a small
amount of blue loctite to the threads.
frame assembly Use two 5mm allen keys to secure the male/
15
female connection.
torque spec: 125-150 inch pounds.
frame assembly repeat steps 14 and 15 for the shock position
16
mounting bolt.