Initial Setups; Initial Setting; Channel Setting - FUNAI W4D-D4180DB Owner's Manual

E9G04ED_EN.book Page 19 Tuesday, March 27, 2007 10:27 AM

Initial Setups

Initial Setting

Turn on this unit for the first time, you need to follow
these steps.
1
Press [STANDBY-ON].
2
Turn the TV on. Select the input to
which the unit is connected.
"Initial Setting" will automatically appear.
3
Select your desired language for the
OSD using [U / D]. Then press
[ENTER] to go to the next step.
Initial Setting
Initial Setting
4
Press [ENTER] to start Channel Tuning.
The unit will start getting channels available in
your area.
Initial Setting
Auto Tuning
Make sure the antenna is
connected to "ANTENNA IN" jack.
5
After finished channel setting,
"Clock Setting" will appear. Then
press [ENTER].
Initial Setting
Clock Setting
- - / - - / - - - - ( - - - )
6
Follow to step 5 on page 22 in
"Manual Clock Setting".
English
Deutsch
РУССКИЙ
Česky
Magyar
Polski
Romania
Български
Start
- - : - -

Channel Setting

Tuning of this unit to broadcast channels can be
performed in two ways.
Auto Tuning
Programme the tuner to scan only the channels you
can receive in your area.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U / D],
then press [ENTER].
General Setting Menu will appear.
2
Select "Channel" using [U / D], then
press [ENTER].
3
Select "Auto Tuning" using [U / D],
then press [ENTER].
The unit will start storing channels available in
your area.
General Setting
Playback
Display Auto Tuning
Video Manual Tuning
Recording Move
Clock
Channel
DivX
Reset All
Wait for several minutes to finish channel storing.
4
Press [SETUP] to exit.
You can select the channels memorised only in
this unit by using [PROG. U / D].
To cancel auto tuning
Press [RETURN R] or [SETUP] during scanning.
Note
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning,
some channels not yet tuned may not be received.
• You cannot change the channel when either VCR or
DVD is in any recording mode (normal recording,
One-touch Timer Recording or timer recording).
19
EN