Installing Batteries In The Remote Control; Vcr / Dvd Recorder Switching - FUNAI W4D-D4180DB Owner's Manual

E9G04ED_EN.book Page 12 Tuesday, March 27, 2007 10:27 AM
Installing Batteries in the
Remote Control
Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the polarity
indicated inside the battery compartment.
1 2
Caution
• Incorrect use of batteries can result in hazards such
as leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus and minus ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used
for a month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions
for environmental protection that apply in your
country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
About the Remote Control
• Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
Within about
7 m
30˚
30˚
Remote control
• The maximum operable range as follows:
Line of sight:
Either side of centre: approximately 5 m within
• Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
• Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
• Replace the batteries when the operating range of
the remote control reduces.
EN
3
Within about
5 m
approximately 7 m
30 degrees
12

VCR / DVD Recorder Switching

Because this product is a combination of a VCR and a
DVD recorder, you must select first which component
you wish to operate.
Device Select Buttons / Indicators
OPEN/CLOSE
PAL
REW F.FWD STOP/EJECT PLAY RECORD PROG. DUBBING
STANDBY-ON
SELECT
VCR DVD
SELECT
DVD SELECT indicator
VCR SELECT indicator
VCR button
DVD button
VCR mode
Press [VCR ] on the remote control.
(Verify that the VCR SELECT indicator is lit.)
DVD mode
Press [DVD ] on the remote control.
(Verify that the DVD SELECT indicator is lit.)
Note
• You can also press [SELECT L P] on the front
panel to switch between DVD and VCR mode.
• You cannot switch to the mode (DVD or VCR) that is
in the timer-standby mode.
SELECT STOP PLAY RECORD
VCR SELECT DVD
S-VIDEO VIDEO L(MONO)-AUDIO-R
STANDBY-ON OPEN/CLOSE
T-SET
.@/: ABC DEF
1 2 3
PROG.
GHI JKL MNO
4 5 6
PQRS TUV WXYZ INPUT SELECT
7 8 9
DISPLAY SPACE CLEAR SETUP
0
TOP MENU MENU/LIST RETURN ENTER
REC/OTR VCR DVD CM SKIP
TIMER PROG. PLAY
REC SPEED SKIP PAUSE SKIP
SYSTEM X1.3/0.8 STOP AUDIO
DUBBING SEARCH REPEAT ZOOM