Chopper/Grinder Attachment; Reversible Blade - Cuisinart CSB-300 Instruction And Recipe Booklet

CHOPPER/GRINDER
1. Place the chopping/grinding blade
assembly into center of the chopping
cup over metal blade shaft.
2. Place your ingredients into the chopper
cup. Close cover, rotating clockwise to
lock in place.
3. Connect the power handle to the top of
the chopping cup cover until you hear a
slight click.

REVERSIBLE BLADE

The chopper/grinder attachment is equipped
with a reversible blade – sharp on one side
and blunt on the other. The blade is attached
to a plastic ring that slides over the plastic blade shaft, so it can be
easily turned over to select the appropriate blade. To reverse the
blade, see detailed instructions below. Also see Frequent Uses for
Chopper/Grinder (page 16).
Assemble the parts.
1. Place the chopping cup on a flat, dry, stable surface.
2. The metal blade assembly shaft (A) is attached to the bottom of the
chopping cup. If not already in place, slide the fully assembled
blade assembly (B) over the top of the metal blade assembly shaft.
2a. Put together the blade assembly if not
assembled: Very carefully connect the
blade ring (C) to the plastic blade shaft
(D). Line up the blade ring opening with
the plastic sheath. There are notches (E)
on opposite sides of the
interior of the ring. These fit over ridges on
the sides of the plastic blade sheath (G).
Let the blade ring slide to the bottom of
the plastic shaft. HOLD THE BLADE RING BY THE CENTRAL
HUB HOLDING RIBS (grips) (F) ONLY. DO NOT TOUCH THE
RAZOR-SHARP BLADES. Pick up the blade ring by its hub
holding ribs (grips) and turn it very slightly clockwise. This locks it
in place on the plastic blade sheath and prevents it from sliding
up during processing. Note these important features of the blade
ring. The blade ring can be placed over the plastic blade shaft in
two different ways: If you hold it this
way (A), you will see the word "Sharp"
on the blade. Assemble the blade this
side up to use the sharp edge. If you
hold it this way (B), you will see no
writing on the blade. Assemble the
blade this side up to use the blunt
edge. (See the section on processing
9
chopping
cup cover
E
F
G
D
B
A
C