Removal Of The Battery Ignitor; Repacing The Battery - Flavel FSCC12MN Installation And Maintenance Instructions Manual

Stirling mc & sc

Hide thumbs

Table Of Contents

Table of Contents

4.5.3

Isolate the gas supply and remove the inlet pipe from the appliance inlet

elbow. To allow burner removal, the control lever operating cable must

be removed. The control lever operating cable can be seen running

across the base of the fire, below the burner. To release the cable,

unscrew the cable securing screw located in the centre of the aluminium

operating arm and pull the cable out from its fixing hole. Release the

other end of the cable by pushing the cable towards the right i.e. into

the operating arm so as to release the tension. Pull the cable nipple out

of the retaining hole and remove the cable through the slot in the

operating arm. Remove the two retaining screws at the base of the

burner unit, and the screw each side of the burner unit. The base of the

burner unit can now be pulled forward, allowing the burner to be

removed outwards and downwards from the fire box. Remove the

burner assembly from the fire.

4.5.4

Refit the burner assembly to the firebox by carefully pushing the bottom

of the burner back into position. Secure using the two screws into the

side frame of the firebox, and two screws into the base.

It is now necessary to refit and correctly tension the operating cable. To

do this, first set the control lever to the horizontal (central position), this

is the position which creates maximum tension in the operating cable.

Refit the operating cable to the aluminium operating arm, firstly locating

the nipple on one end of the cable into recess in operating arm and

then feed the other end through hole in operating arm. Pull the operat

ing cable until it is finger tight and secure with screw into operating arm

(do not over-tighten). Move the control lever fully downwards and check

that the left hand micro-switch operates the igniter and that the control

valve spindle is fully depressed. Move the control lever upwards to the

"off" position and check that the right hand (cut-off) micro-switch

operates. Check that the control lever operates smoothly and safely.

Refit the coals as shown in section 3, refit the fender / ashpan cover

and trim.

4.6