Removal Of The Battery Igniter (Slide Control Models); Replacing The Battery (Slide Control Models) - Flavel Kenilworth Installation, Maintenance & User Instructions

4.5.3 Isolate the gas supply and remove the inlet pipe from the appliance inlet
elbow. The control lever operating cable can be seen running across
the base of the fire, below the burner. To release the cable, unscrew
the cable securing screw located in the centre of the aluminium
operating arm and release the front part of the operating arm, thereby
freeing the cable from the burner (see figure 27 overpage). Note the
securing screw is retained in the block to prevent it from being lost.
Release the other end of the cable by pushing the cable to the right, i.e.
into the operating arm so as to release the tension. Remove the two
retaining screws at the base of the burner unit, and the screw each side
of the burner unit. The base of the burner unit can now be pulled
forward, allowing the burner to be removed outwards and downwards
from the fire box. Remove the burner assembly from the fire.
4.5.4 Refit the burner assembly to the firebox by carefully pushing the bottom
of the burner back into position. Secure using the two screws into the
side frame of the firebox, and two screws into the base.
It is now necessary to refit the operating arm front section to the rear
section (reverse of procedure described above), when this is completed,
move the control lever fully downwards and check that the left hand
micro-switch operates the igniter and that the control valve spindle is
fully depressed. Move the control lever upwards to the "off" position
and check that the right hand (cut-off) micro-switch operates. Check
that the control lever operates smoothly and safely. Refit the coals /
pebbles as shown in section 3, refit the fender / ashpan cover and trim.
4.6 Removal of the battery ignitor
4.6.1 Remove the burner assembly as above.
4.6.2 Disconnect the ignition lead and 2 off microswitch leads from the igniter.
Unscrew the Battery retaining cap and place battery to one side. Then
unscrew igniter retaining ring and remove igniter from panel.
Re-assemble in reverse order and carry out a gas tightness test.
4.7 Replacing the battery
4.7.1 Unscrew Battery retaining cap situated at the front right of the fire and
remove the battery
4.7.2 Replace in the reverse order using a 1.5V AA Alkaline Battery.
39