Table of Contents
Advertisement
DAC-2202 Technical Specifications
17.
DAC-2202 Technical Specifications
The technical specifications for the DAC-2202 ACU and some of the specifications for general Below Decks are:
17.1.
DAC-2202 Antenna Control Unit
The technical specifications for the DAC-2202 ACU are:
17.1.1.
Physical Dimensions:
Input Voltage:
Power Requirements:
Weight
17.1.2.
Status Indicator Display:
Alpha Numeric Display:
Next Button
4-Position Keypad
Enter Button
Reset Button
Controls:
17.1.3.
Connectors:
J1 "Ship Gyro"
J2 "NMEA" RS-422 Serial I/O
J3 "M&C" RS-422 Serial I/O
J4A "Antenna" RS-422
J4B "Antenna" Control IF and
J6 "RF IN" Tracking Receiver
J7 "RF OUT" Tracking Receiver
"Ethernet"
"AC Input Power 95-250VAC"
17.1.4.
Communications Parameters:
Interface Protocol:
Base Modem Power:
Interface Connector:
General
Front Panel
Rear Panel
Pedestal M&C
Pedestal DC Power
IF Input
IF Output
J4A "Antenna" Pedestal M&C Interface
4009-33 Installation Manual
Rackmount: 1.75" x 17" x 14"
110/220 VAC, 50/60 Hz
160 Watts maximum
2.8 kg (6.2 lbs)
6 LED enunciators for Tracking, Searching, Target, Power, Initializing,
and Error
2 Line 20 Character Alpha Numeric
Cycles display between Ship, Satellite, Antenna, and Status
Cycles cursor Up / Down / Left / Right
AC Power On/Off
25 pin female D-Subminiature
9 pin male D-Subminiature
9 pin female D-Subminiature
9 pin female D-Subminiature
Type F female
Type F female
Type F female
RJ-45
IEC receptacle
9600 Baud, 8 bits, No parity, 1Stop Bit
Full Duplex RS-422
30 Volts DC
9 pin male D-Subminiature
17-1
Advertisement
Table of Contents
