Functional Description - Porter-Cable PC70THD Instruction Manual

• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
Volts
120V
240V
Ampere Rating
More
Than
0
6
10
12

FUNCTIONAL DESCRIPTION

Figure A
1. Variable speed switch
2. Lock-on button
3. Forward/reverse slider
4. Two-gear selector
5. Drilling mode selector
6. Chuck
7. Chuck key & strap
8. Depth stop rod
9. Side handle
Safety Warnings and
Instructions: Drills
WARNING:
1. Hold drill firmly with one hand on the
grip and the other hand on the side
handle as shown in figure B.
2. When attaching accessories in the
drill chuck, tighten with all three holes
to prevent slippage.
Minimum Gauge for Cord Sets
Total Length of Cord in Feet
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
- 6 18
- 10 18
- 12 16
- 16 14
26-50 51-100
51-100 101-200
American Wire Gauge
16 16
16 14
16 14
12 Not Recommended
A
6
8
9
B
5
101-150
201-300
14
12
12
5
3
4
1
7
2