Wolf Garten Robo Scooter 1800 Operating Instructions Manual page 18

Lay the Template on the ground at the entrance to the Narrow
Pass:
The arrow points towards the entrance to the
Narrow Pass, in the direction of the Sub-Zone.
Insert by hand (half-way in) 7 pegs into the 7 holes
numbered 1 – 7 .
Lift the Template up so the pegs are left loosely stuck in the
ground.
Lay the Perimeter Wire through the four right-side pegs numbered
1 – 4
Hold the wire around each peg 1 , 2 , 3 , 4 while
driving the peg all the way into the ground.
Leave pegs 5 – 7 standing half-way out. They will be
connected to the wire later.
Continue laying the Perimeter Wire through the pass towards
the Sub-Zone:
Straight line at a minimum distance of 45 cm (1.5 ft.) from
the pass right side edge.
Pause at the end of the Pass in order to set the other end
of the Narrow Pass.
There should be a 40 cm (1.3 ft.) distance between the Sub-
Zone Perimeter Wire and the pass exit.
Turn the Template and lay it on the ground at the entrance to
the Sub-Zone:
The arrow points towards the Sub-Zone.
Insert by hand (half-way in) 7 pegs into the 7 holes
numbered 1 – 7.
Lift the Template up so the pegs are left loosely stuck in the
ground.
Lay the Perimeter Wire through the three right side pegs
numbered 1 – 3
Hold the wire around each peg 1, 2, 3 while driving the
peg all the way into the ground.
18
Main Zone
Main Zone
Main Zone
Turn the Template and lay it on the ground
Main Zone
Lay Perimeter Wire through
Main Zone
10
Lay the Template
Sub-Zone
Starting the Sub-Zone Passage setup
1 7
Insert – pegs
Sub-Zone
Lay Perimeter Wire
1 4
through –
Sub-Zone
Insert 1 – 7
pegs
1 – 3
pegs
Sub-Zone
pegs
Sub-Zone
en