Table of Contents
Advertisement
Feed both the Perimeter Wire (A) and the Extension Cable (B)
through the slot in the rear side of the Base Station.
Attach the Perimeter Wire connector to the Base Station Head (A).
Attach the 20 m (65 ft.) Extension Cable to the Base Station Head (B), if
not already connected.
Make sure that the Perimeter Wire and the 20 m (65 ft.) Extension Cable
are through the slot in the back of the Base Station.
Align the Base Station Head to the front of the Base Station (C).
Slide it in place along the side channels.
Push forward until the Head clicks into place.
Feed the 20 m (65 ft.) Extension Cable all the way to the Power
Box.
2.7
Placing The Base Station
Place Base Station on the Perimeter Wire.
Position the Base Station front facing a Anti Clockwise direction along the
lawn's edge.
Place the Base Station on the Perimeter Wire.
Align the center marking on the front of the Base with the wire.
After the Base Station has been positioned, insert 2 rear stakes into the
Base Station holes. Only after the complete setup will be tested, you will
insert the 4 remaining stakes (See Section 3.3.5).
22
14
A
B
B B
A A
C C
Insert 2 rear
stakes
en
Advertisement
Table of Contents
