Remote Control Functions - Jøtul GI 635 DV IPI Installation And Operation Instructions Manual

139712_R00_GI 635 IPI Sept. 2015

Remote Control Functions

Pilot Mode Control
The IPI/CPI functionality will be fully controlled by

the remote transmitter. See Pilot Mode, page 35.
ON - Set the insert burner switch to ON to enable

the remote control burner operation.
OFF - Turns off burner functionality. Switch to OFF

when the fireplace will not be used for an extended
period of time. The accent lamp and blower
functionality will continue to be available with the
remote set to OFF.
Remote Transmitter
The Transmitter features a simple button layout and
informative display screen. See figs. 63-64.
LCD DISPLAY - graphically indicates temperature
settings and status of the Thermostat, Burner, Fan, and
Accent Lamp.
ON / OFF Key - controls Burner, Fan, and Lamp functions.
THERMOSTAT Key - Used to set either Manual or
Thermostatic Control and index through thermostatic
functions.
UP / DOWN Arrow Key - Selects thermostat
temperature range, fan speed, and flame height.
MODE Key - used to select the component to be
controlled: CPI/IPI, Burner, Blowers, and Accent Lamp.
The included Wall Mount Bracket can be used for
convenient Transmitter storage away from curious
children.
Transmission
Thermostat
ON / OFF / SMART
Set Point
Temperature Level State
Burner
Modulation
Fan Modulation
Figure 64. Remote transmitter display data.
34
°F
°C
OFF
ON
SMART
MAX
MAX
Lamp Modulation
IFC / Transmitter Mode Synchronization
1. Set the Burner Switch to OFF, (located in the right side
compartment).
2. Install three AAA batteries into the Transmitter.
3. Press the red initialization button on the left top
corner of the IFC board, just behind the switch
plate.(fig. 58, page 30). The board will "beep" three
times and a yellow LED indicates a 10-second
synchronization time limit.
4. Within the 10-second time frame, push the ON button
on the Transmitter. The IFC will "beep" three or four
times to indicate that it has acknowledged the
transmitter command and sets to the particular code
of that Transmitter.
5. After initialization, the burner switch must be placed
in the ON position and Remote Mode placed in CPI.
The remote can then be used to control the burner.
To return to full Manual functionality, hold the red
initialization button down until it "beeps" three or
four times and the yellow LED illuminates. Within
10 seconds, push the button again until it signals the
acknowledgement.
NOTE: In Manual functionality, there is no control
over the blower, lamp, or pilot modes. The pilot
automatically defaults to CPI mode.
Figure 63.
Remote transmitter
function keys.
Child Safety Lock-out
Low Battery Alarm
Room
Temperature
CPI Mode
AUX
(Not Applicable)
Split Valve
Blue LCD Screen
ON/OFF Key
THERMOSTAT Key
UP/DOWN Key
MODE Key