Digital In/Out Jacks; Dc In 13V Jack; I/O Port; O Port - Marantz PMD670 User Manual

Security
The supplied
Memory compart-
ment security screw requires
using a small Phillips screwdriver
to open the Memory compartment
door. That reduces the possibility that the CF card will
be misplaced or stolen.
1. Remove the plastic pin (c) and then the
retainer (d).
2. Add the screw. Tighten the screw with a small
Phillips screwdriver tight enough so the screw
cannot be removed with a fingernail.
Left side continued
CHARGE
DC IN 13V
I/O
14 15
DIGITAL
IN
OUT
(3mm x
10mm long)
d
c
13
DIGITAL
IN
OUT

13. DIGITAL IN/OUT jacks

RCA jacks for connect-
ing the PMD670 to an
audio component that
accepts or outputs digital
audio signals.
IN: Connect to the digital out of a digital audio
component. PCM audio data input at 44.1 and 48
kHz can be recorded.
This input has to be selected in the Input menu for
the signal to be recorded. See INPUT button.
OUT: Connect to the digital in of a digital audio
component.
• Only files with sample frequencies of 48 or
44.1kHz can be output.
• Digital audio is only output during normal or
EDL playback.
• The receiving component must be able to
accept audio in SPDIF (IEC-958-II) format.
• The receiving component must be able to
accept a sampling frequency of 48 or
44.1kHz.
DC IN 13V
if it was running on battery power. If AC power is
interrupted by a power outage or unplugging the
adapter the PMD670 automatically switches to
battery power.
I/O
The connection makes it easy to copy audio files
to your computer's hard drive or a CD. The I/O
connection can only be made active when the
PMD670 is off (neither recording or during play-
back).
- 42 -

14. DC IN 13V jack

Plug the supplied AC
adapter in here. The power
supplied is 1.0A at 13V AC.
The PMD670 automatically
switches to adapter power

15. I/O port

Plug the supplied I/O cable in
here and connect the other end
to your computer (PC or MAC).