Controls And Connections; Top; Speaker; Mic (Internal Microphone) - Marantz PMD670 User Manual

Controls and Connections

SOLID STATE RECORDER PMD670
POWER
3

Top

1. Speaker

The played back audio signal is simulta-
neously output to the built-in speaker, the
PHONES jack, LINE OUT jacks and DIGITAL
OUT jack. Headphones plugged into the
PHONES jack mutes the internal speaker.
The HP/SPK VOLUME control controls the
built-in Speaker and Headphone volume.

2. MIC (internal microphone)

POWER
nected at DC IN and plugged in, it powers the
PMD670.
If power is not detected at DC IN, battery power is
automatically used if available.
When first powered up the PMD670 takes some
time to initialize.
Loading is dis-
played, then a blank
screen for a while.
Reading is dis-
played while the CF
card is read.
1 2

EDIT

iNPUT A-B REPEAT MARK
TRACK JUMP
- / REW FWD / +
REC
UNDO
MARGIN RESET PLAY / PAUSE STOP
I / O MENU/STORE ENTER CANCEL
4

3. POWER switch

Slide to the right and release
to turn Power on or off.
If the AC adaptor is con-
L
-dB
00 40 20
R
L
-dB
00 40 20
R
setup controls relatively unavailable. The setup
controls allow you to setup the PMD670 for your
unique application. You can then have someone
operate the PMD670 without concern that they
might change something that could cause failure
to record.

Recording setup controls

5
OFF
AUTO MARK
ON: During record, a pause (pushing the REC
PAUSE button) adds an EDL mark to the track.
During record an EDL mark is added to the track
if a remote device (plugged into the REMOTE
jack) is used to pause recording.
OFF: Pausing during record does not add an
EDL mark to the track.
Factory default: AUTO MARK switch ON.
12 6 2 0 over
-dB
12 6 2 0 over
-dB
- 14 -

4. Security cover

Use a small Phillips screw-
driver to remove or replace
the Security cover.
The Security cover makes
Note: Two 3mm machine
screws 10mm long are used for
the security cover.
STEREO
OFF ON
R
L
AUTO MARK
ANALOG OUT
SINGLE
ON
OFF ALL
OFF
PRE REC
OFF ON
ON OFF
INPUT LOCK EDL PLAY
EDIT
INPUT A-B REPEAT
MARK
ON

5. AUTO MARK switch

Turns the automatic EDL
mark feature on or off.
0dB -20dB
MIC ATTEN
FLAT
ANC
LIMITER
ALC MANUAL
LEVEL CONT.