Replacing Sealing Ring - Gilera Stalker 50 Service Manual

Stalker 50
Loctite 243 Medium strength threadlock
Loctite 243 medium-strength threadlock
Locking torques (N*m)
Stud-stanchion fixing screw
tightening torque
20 to 25 N•m

Replacing sealing ring

- Remove the wheel axle.
- Remove the screw (4).
- Remove the stanchion (3).
- Remove the dust guard (1).
- Insert the new sealing ring after lubricating the
inside parts of the ring and paying attention not to
damage it.
- Insert the stanchion appIying the recommended
product to the clean surface.
- Lock the screw (4).
Recommended products
Loctite 243 Medium strength threadlock
Loctite 243 medium-strength threadlock
Refitting
Lubricate the seats and the balls with the grease
recommended.
- Lock at the prescribed torque and turn the key
anticlockwise by 90° to 100°.
Specific tooling
020055Y Wrench for steering tube ring nut
Recommended products
AGIP GREASE PV2 Grease for control levers
on the engine
White anhydrous-calcium based grease to protect
roller bearings; temperature range between -20 °
C and +120 °C; NLGI 2; ISO-L-XBCIB2
Locking torques (N*m)
Locking torque:
50 to 60 Nm
Nut
20 to 25 N•m
Suspensions
SUSP - 93