Stalker 50
Knee-guard
- Remove the central chassis cover.
- Remove the footrest.
- Remove the eight screws shown in the figure
(four on each side).
- Remove the luggage rack hook by turning the two
screws.
- Pull the shield back plate down.
For installation, reverse the removal sequence,
paying attention to the correct assembly of the
lower fittings.
Taillight assy.
To replace the bulbs it is sufficient to remove the
two screws shown in the figure and to then pull off
the glass of the rear headlight.
During assembly, pay attention to correctly install
the glass of the turn indicators.
Chassis
CHAS - 111