Sas Malfunctions; Transmission And Brakes; Clutch Grabbing Or Performing Inadequately; Insufficient Braking - Gilera Stalker 50 Service Manual

Stalker 50
Possible Cause
Starter inefficient

SAS malfunctions

SLACKENING OF THE RUBBER JOINT OF THE SECONDARY AIR PIPE ON THE MUF-
Possible Cause
Secondary air reed blocking
Secondary air filter clogging
Blockage of the secondary air fitting on the muffler

Transmission and brakes

Clutch grabbing or performing inadequately

Possible Cause
Tear or irregular functioning

Insufficient braking

Possible Cause
Poor braking
Air bubbles inside the hydraulic braking system
Fluid leakage in hydraulic braking system
The brake fluid has lost its properties
Defective sliding of the cables in their sheathes
Brake noise
Check: electric wiring, circuit continuity, mechanical sliding and
FLER
Remove the encrustations from the joint being careful not to let
CLUTCH
Check that the masses open and return normally
Check that the clutch masses' contact surface with
the clutch bell is mainly in the middle with charac-
Check that the clutch bell is not scored or worn
Never operate the engine without the clutch bell
BRAKING SYSTEM MALFUNCTION
The rear (drum type) brake is adjusted by regulating the special
adjustment (on the wheel) bearing in mind that, with the control
The braking action should begin when the brake
If it is not possible to remove any problems by sim-
ply adjusting the transmissions, check the brake
pads and front brake disc, the brake shoes and the
rear drum. If you encounter excessive wear or
Carefully bleed the hydraulic braking system, (there must be
Elastic fittings, piston seals or brake pump breakdown, replace
Replace the front brake fluid and top up to the correct level in
Operation
power supply
Operation
Replace
Clean the filter and the housing
the debris fall into the muffler
Operation
Check that there is no grease on the masses
teristics equivalent on the three masses
abnormally
Operation
levers in the rest position, the wheels must turn freely.
levers are pressed by about a third.
Check the brake pad wear.
scoring, make the necessary replacements.
no flexible movement of the brake lever).
the pump
Lubricate or substitute
Check the wear of the brake pads and/or shoes
Troubleshooting
TROUBL - 35