Cautions - Toshiba e-STUDIO 12 Operator's Manual

CAUTIONS

Follow the cautions below when using this copier.
1
Cautions on laser
Wave length
Pulse times
Output power
Trademark acknowledgment
PCL is a trademark of Hewlett-Packard Company.
All other trademark and copyrights are the property of their respective owners.
4
The fusing area is hot. Exercise care in this area when removing misfed paper.
Do not look directly at the light source. Doing so may damage your eyes.
Do not switch the copier rapidly on and off. After turning the copier off, wait 10
to 15 seconds before turning it back on.
Copier power must be turned off before installing any supplies.
Place the copier on a firm, level surface.
Do not install the copier in a humid or dusty location.
When the copier is not used for a long time, for example, for consecutive
holidays, turn the power switch off and remove the power cord from the outlet.
When moving the copier, be sure to turn the power switch off and remove the
power cord from the outlet.
Do not cover the copier with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the copier.
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
770 nm - 795 nm
11.82 µs/7 mm
0.17 mW ± 0.01 mW