Table of Contents
Advertisement
Auto Setup Options
Auto Setup Options determine what will happen automatically and what will not. To
access the
Each checkbox in the
selecting it (using the up/down arrows) and pressing
Retry on Lost Signal
Occurs only when the present signal (picture) disappears or changes in some way. If
this item is not checked, the display will not try to sync to a new signal. Keep this
menu item checked.
Note:
computer, is a valid picture. The signal itself (the sync pulses) must be lost to trigger a search.
"Do" Checkboxes
Each
processes are completed.
In the following situations, each of the checked
shown in the menu:
Do Frequency and Do Phase
Work separately to find the frequency and phase of the computer picture and adjust
to them. These work best on a picture that has a lot of sharp changes in brightness,
such as text (adjacent white and black pixels).
Do Position
Centers the picture on the screen.
AUTO SETUP OPTIONS
A ut o S et up O pt i o n s
AUTO SETUP OPTIONS
Searching will not occur because the picture goes black. Black, from video or from a
that is checked
DO
• If a new signal is acquired, either through selecting a different connector or
because the source picture has changed modes, such as from WXGA to UXGA.
• When you press the
m70L Installation & Configuration Guide
menu, press
MISC
Re t ry on Lo st Sig n al
Do Fr eq u en cy
Do Ph ase
Do Po sit i on
menu can be turned on or off by
will adjust the display, one process at a time, until all the
button on the remote.
SETUP
five times on the remote.
.
ENTER
boxes will be done in the order
DO
Advanced Options
55
Advertisement
Table of Contents
