Operating Sequence; Using The Appliance - Electrolux EVE611SA User Manual

Hide thumbs Also See for EVE611SA:
Table of Contents

Advertisement

10 EVE611SA, EVE614BA

OPERATING SEQUENCE

Select the cooking function
Turn the function selector in any direction to the
desired cooking function. The oven cavity light will
come on.
Select the temperature
To set the temperature, turn the temperature
selector in a clockwise direction to the desired setting.
An indicator light in the display will come on.
A thermostat controls the temperature in your oven.
When the temperature is reached, the heating source
switches itself off and the indicator light goes out.
When the oven temperature falls below the desired
setting, the heating source switches on and the
indicator light comes on again.
Once the food is cooked, turn the temperature
selector back in an anti-clockwise direction. Do not
force it right round in a clockwise direction as this will
result in damage to the thermostat.
Note: The desired cooking function must be selected
before the oven will operate.
IMPORTANT!
Pre-heating
For best cooking results pre-heat the oven. Pre-heating
allows the oven to reach the required temperature
quickly and efficiently as well as cook food at the
correct temperature for the entire cook time.
1. With 'Rapid Heat' function
This function allows the oven to reach preset
temperature quicker than any other cooking function.
Turn the function selector to 'Rapid Heat', then set
the desired temperature, by rotating the oven
temperature selector.
When the heating light goes out, the oven has reached
the desired temperature. Select the oven function
required and place the food in the oven.
2. With other oven functions
Set the desired temperature by rotating your oven
temperature selector. When the indicator light goes out
the oven has reached the desired preset temperature,
place your food in the oven, close the door and set the
timer if you desire.
3. With 'Grill' function
Pre-heat the grill for at least 3 minutes to obtain best
results. This will help to seal the natural juices of steak,
chops and other meats for a better flavour.

USING THE APPLIANCE

IMPORTANT!
Cooling / Vent fan
The built-in appliance is fitted with a cooling fan. This
prevents the kitchen cabinet from overheating and reduces
the condensation inside the oven. It will operate whenever
the oven is in use and blow warm air across the top of the
oven door.
Note: If the oven is still hot from cooking, the cooling fan
will keep running to cool the oven down and will switch
off by itself once cool.
Condensation
Excess condensation may fog the oven door. This may
happen when cooking large quantities of food from a
cold start. Minimise condensation by:
– Keeping the amount of water used whilst cooking to
a minimum.
– Making sure the oven door is firmly closed.
– Baking custard in a baking dish that is slightly
smaller than the water container.
– Cooking casseroles with the lid on.
Note: If using water in cooking, this will turn to steam
and may condense outside your appliance. This is not a
problem or fault with your oven.
Cooking with the timer
The appliance is equipped with a timer that has the
following features:
Timer – sets a countdown time that will beep when
the set time has elapsed.
Cook time – sets cooking duration. A timer will count
down the preset cooking time, beep when the time
has elapsed and turn the appliance off.
End time – instead of setting a cooking duration, a
cooking finish time can be set. When the finish time
has been reached the timer will beep and turn the
appliance off.
Delayed start cooking time – combines the cooking
time and end cooking time to switch oven on and off
at a specific time during the day.
EVE611SA, EVE614BA 11
Selecting the timer
Touch the MODE symbol until the timer
icon
begins flashing.
Set the countdown time you want by using the
+
and
symbols. 5 seconds after the last change
the timer 'icon will stop flashing and the countdown
will start in minutes.
To stop the beeper, touch any symbol.
Maximum countdown time is 2hrs 30mins.
Setting the cooking duration
Select the desired oven function and temperature.
The oven indicator light will glow and the heating
source will come on.
Touch the MODE symbol until the cook time icon
begins flashing.
+
Set the cooking duration you want by using the
and
symbols. Five seconds after the last change the
cook time icon will stop flashing, and the time of day
will be displayed. The oven will automatically shut off
once the set duration is reached. To check how much
time remains, press MODE until the cook time icon is
lit. The remaining time will be displayed.
When the oven shuts off an alarm will beep. To stop
the beeper, touch any symbol.
Note: Remember to add pre-heating time if necessary.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents