Check Ignition Spark - Valor 492CNA Installer's & Owner's Manual

2. UNPACKING
The
carton contains the following:-
1
Heater assembly.
3
Ceramic logs.
1 Flue collar.
1
Pack fixing screws.
2
Plastic caps for foot screws.
1
Smoke match tube.
Remove all the items carefully to prevent damage.
Some items may
be
contained in the packaging
fitments
-
Examine the packaging carefully before
discarding. Check that ail the items are present and
undamaged.
PREPARATION
Stand the heater upright.
Detach the window trim unit by sliding its side
channels upwards to clear the location
brackets on the window frame sides. Pull the
bottom ofthe trim unit forward slightly and then
pull down to clear the outer case hood
-
see
figure
5,
Remove the window unit by detaching the
knurled screws at the sides near the top. Lift
the window unit up to clear locations at the
bottom and place carefully aside (see fig.
6).
1
-
Remove 2 Knurled Screws
2
-
Lilt Window Clear o f Locations
Fig. 6 WINDOW UNIT REM WAl
Remove the control knob by pulling clear from
the control valve spindle.
Detach the control bezel by removing the
knurled screw below the control knob opening
(see figure 1 ) .
Remove the knurled screws at the case sides
(see fig. 7).
/7
Pull the bottom of the case forwards. Lift the
case upwards to clear the top rear brackets
then lift forwards to clear. Place carefully
aside.
Fit
the flue collar to the back of the heater
using the four screws provided.
4.
CHECK IGNITION SPARK
The pilot electrode is situated at the right side
of the firebox above the rear port of the pilot
& cross lighting burner
-
See figure 7.
Check that there is an ignition spark at the
pilot port.