Valor 492CNA Installer's & Owner's Manual page 12

Make sure that the logs are not dislodged
when refitting the case.
If necessary, adjust the brass andirons at the
casing front sides by slackening the screws
behind the andirons and moving the andirons
until they rest on the hearth. Retighten the
screws.
Refit the window trim.
MAKE FINAL CHECKS AND INSTRUCT
OWNER
Recheck the operation of the fire on
all
control positions.
Instruct the owner howto correctly operate the
..
heater and especially point out the following;-
The heater has a pilot. To light the pilot, the
control knob must be depressed and turned
to the IGN position.
The pilot flame
can
be viewed to check that it
is alight. Show the owner where to view the
pilot. Point out the illustration showing how to
view the pilot.
Explain the full lighting and control position
sequence and how to turn o f f .
Advise that the fire can be lit with a long
match or taper if necessary.
Advise that the window will require cleaning
periodically both outside and inside as
described in the instructions. Explain how to
remove and replace the window unit and logs
for cleaning etc. Stress that cleaning should
only be carried out when the heater is cold.
Advise that the fire may give off a slight odor
while new. This is normal and it will disappear
after a short period of use.
Advise that the bright metal firebox interior will
color with use and that this is quite normal.
Emphasise that if the glass panel is. broken
or damaged, the heater should be turned off
and not used until the window unit is refitted
with an authorized replacement.