Log Installation - Valor 492CNA Installer's & Owner's Manual

The appliance must be isolated from
the gas supply piping system
by dosing its individual manual shutoff vatve
during any pressure testing of the gas supply
piping system at test pressures equal to or
less than 112psig (3.5kPa).
All piping and connections must be tested for
leaks after installation or servicing.
All leaks must be corrected immediately.
When testing for leaks:-
(a)
Make sure that the appliance control
knob is at the OFF position.
(b)
Open the manual shut-off valve.
(c)
Test for leaks by applying a liquid
detergent or soap solution to all joints.
Bubbles forming indicate a gas leak.
NEVER USE AN OPEN FLAME TO
CHECK FOR LEAKS.
(d)
Correct any leak detected immediately.
Refit the firebox floor panel when testing
results are satisfactory.
7.
LOG INSTALLATION
7.1.
Place the rear log (the log with only one short
stub) in the retaining cradle behind the rear
burner tube with its back against the firebox
back wall (fig.
9).
The short stub should be at
the top right
of
the log. Center the log so that
the gap to the firebox walls is the same at each
side.
7 . 2 . Place
the
front log on the retaining cradles
between the rear and front bumer tubes
(fig. 10). Center the log so
that the gap to the
firebox walls is the same at each side.
7.3.
Place the cross log in position (see fig. 11).
The front of this log is indicated by the letter
"Fu embossed on its underside. Makesure that
the front of the log is seated inside the hollow
in the front log and is not raised in front of it.
7.4.
Replace the window unit. Locate its bottom
edge in the support channels at the firebox
sides. Refix the knurled screws at the sides
near the top.