Canon MF8580Cdw User Manual page 497

TX Function Settings
Specify settings for sending faxes.
Change Default Settings
Specify settings used for sending faxes. The selected settings are used as the default settings when scanning documents.
Changing Default Settings
Resolution
200 x 100 dpi (Normal)
200 x 200 dpi (Fine)
200 x 200 dpi (Photo)
200 x 400 dpi (Superfine)
400 x 400 dpi (Ultrafine)
Density
Nine Levels
*2
2-Sided Original
Off
Book Type
Calendar Type
Sharpness
Seven Levels
Register Unit Name (Fax)
Register the name of a company or person.
The registered name is sent as sender information to the destination.
ECM TX
Enable or disable error correction mode (ECM). ECM checks for fax data errors and corrects them. To reduce errors on received
faxes, see ECM RX.
Off
On
NOTE
ECM must be enabled on both the machine and the other fax device because error checks are performed on both the
sending and receiving devices.
Even when ECM is enabled, errors may occur due to telephone line conditions.
It may take a longer time than usual to process data when ECM is enabled because the error checks and corrections are
performed while the data is transmitted.
<Fax Settings>
*1
Set Pause Time
For example, when you make calls by dialing "0 - (pause) - (telephone number)", 0 is dialed first and then a few seconds later, the
telephone number. When sending faxes overseas, you need to specify destinations by dialing "(international access code) - (country
code) - (area code) - (fax number)" but consecutive numbers that are input without pauses may not be recognized correctly. In this
case, try adding a pause after the international access code or the fax number. If the code or the number is still not recognized
correctly, change the duration of the pause. For instructions on how to enter a pause, see step 3 on
1 to 4 to 15 (sec.)
Registering the Fax Number and Unit Name
TX Terminal ID
<TX Function Settings> <ECM TX> <On>
Sending Faxes.