Table of Contents
Advertisement
Linear Acoustic AERO.qc User Guide
4.2
Fullscreen Menu Navigation
The Fullscreen metering menu is likely where the AERO.qc will be set during typical use.
Since the majority of the screen is devoted to providing a clear indication of a number of
parameters simultaneously, there is not much room left for menus. Then again, most
things will be set once per session (or once period), and anything requiring adjustment such
as Start/Stop, Apply, and Reset can be controlled by GPI.
The very top of the Fullscreen menu has two important sections. The left area (above the
peak meter) is an indicator only and shows the current mode that will be adjusted by the
right area (above the meter status) which allows selection and adjustment of parameters.
Available adjustment modes are Fullscreen Mode, Meter Options, and RTA Options:
Figure 4-5 Top of Fullscreen Mode screen, showing current mode on the left (Fullscreen
Fullscreen Mode Adjustments:
•
Display - Top of the menu tree, allows selection of 5.1 (Main In 1-6), 2.0 (7/8 in-
put or downmix selected in I/O Settings), 5.1 vs. 2.0, Input Oscilloscope (looks
at 5.1), Output Oscilloscope (looks at 7/8), RTA
•
Input Gain - Provides +/-24dB of gain to input signals
•
Meter Options - Sub-menu for meter settings (see below)
•
RTA Options - Sub-menu for RTA settings (see below)
•
Scope Channel - Adjusts the input channel that drives the oscilloscope
•
Screenshot to USB - Copies the current screen to a timestamped file and stores it
to an installed USB thumb drive.
Meter Options:
•
Target Loudness - Sets static display of target and target marks over bargraph me-
ters. Default is 24.
•
Display Target - On/Off, when Off then Max Loudness is displayed. Target marks
remain over bargraph meters in either mode.
Mode) and parameter that will be adjusted on the right (Display: 5.1).
29
Detailed Operation
Advertisement
Table of Contents
