Table of Contents
Advertisement
Linear Acoustic AERO.qc User Guide
•
•
•
•
•
4.1.6
Record Audio to USB
Allows for capture of audio to an installed USB thumb drive. Note that this is currently
intended for factory diagnosis of audio issues and requires a special player for proper re-
production. With instructions from the factory, 6 or 8 channels of input and/or output au-
dio can be captured and emailed to us to assist with troubleshooting.
4.1.7
Time and Date Settings
Allows configuration of the AERO.qc internal clock for correct time zone, date, and time.
It also allows enabling a Network Time Piece (NTP) service which can automatically con-
nect to a time server and keep time and date synchronized. Depending on the network to
which the AERO.qc is connected, configuration of the facilities Ethernet router may be
necessary
NOTE: The
an IP address from the network. To assign a static IP address, the units MAC
address is provided and the local router can be configured to map the desired
IP address to that unique MAC address.
Monitor Preset - Recalls one of the six available Monitor Presets under the
Monitor Settings menu. For example, setting Monitor Preset 1 to Main 5.1 and
Monitor Preset 2 to Main LoRo allows instant remote switching between 5.1
and LoRo downmixed monitoring of the Main path. See below for more in-
formation on Monitoring setup.
Loudness Meter: Run/Stop - Allows starting/stopping (pausing) meter
Apply Loudness Measurement - Apply the automatically calculated difference
between the loudness measured by the "D" LKFS meter and the target value
as an offset to Input Gain.
Reset Loudness Measurement - Clears the integrator for all meters, does not
reset Input Gain. Note that except for a setting of Infinite, all integrators are
self-clearing (so about 30 seconds for an integration time of 30 seconds).
Next Screen - Advances the Main Screen through the available displays
AERO.qc
has DHCP enabled which means that it will automatically fetch
28
Detailed Operation
Advertisement
Table of Contents
