Table of Contents
Advertisement
Linear Acoustic AERO.qc User Guide
2.4
Quick Setup Notes
The Linear Acoustic AERO.qc is configured at the factory and is ready to go on the air
after making the proper input and output connections and determining if upmixing is de-
sired.
•
Select appropriate reference from the System Options->I/O Options menu (AES Ref,
AES 1, SDI, or Internal 48kHz) and make sure the selected reference is applied to the
unit. If reference is missing, the "double L" signal in the upper right corner of the
screen will flash red. For proper operation it should not be flashing.
•
Apply audio sources to Main AES inputs and/or SDI Input.
•
On a pair-by-pair basis, select the inputs to the processor in the
Options menu.
•
You should see input audio on the top left set of front panel meters, and output audio
on the top right set of front panel meters.
•
You should now have audio outputs on the Main AES outputs, as well as the Monitor
Outputs.
•
Input audio can be monitored by entering Full Screen mode (press the Right side of
the Menu navigation ring).
•
If the loudness is incorrect, it can be adjusted by toggling down to the "Input Attenu-
ator" screen:
•
Press Down on the Menu navigation ring while still in the full screen mode until
"Input Attenuator: xdB" is shown at the top of the screen
•
Rotate the Menu knob to adjust the level until the meter displays a good result
The best way to learn the unit is to explore the different settings with audio applied and
monitored. There are many factory presets to support many different tastes. Some presets
may not sound much different at first, but will perform very depending on program con-
tent.
2.5
Password Programming
After setup, users may wish to password-protect the AERO.qc. This will prevent unau-
thorized or accidental changes to the settings, however please do not forget the password!
Connections and Quick Setup
12
System Options->I/O
Advertisement
Table of Contents
