Cooking Result Trouble Shooting; Quality Cooking Of The Sandwich; Repair Section; Change The Probe Of The Bottom - Electrolux HSG Panini Service Manual

4-1 COOKING RESULT TROUBLE SHOOTING

QUALITY COOKING OF THE SANDWICH

If the sandwich is not enough or to much cooked try another program.
If there is no adequate program follow the trouble shooting here above:
FINDINGS
The core temperature of the sandwich is
too cold
The core temperature of the sandwich is
too hot
The top of the sandwich is burned
The top of the sandwich is not enough
cooked
The bottom of the sandwich is burned
The bottom of the sandwich is not enough
cooked

5. Repair section

Important!
Appliance installation and any maintenance work
must be carried out only by specialized personnel
authorized by the manufacturer. Microwave leakage
must be checked every time you do service to the machine.
In this chapter you will fi nd the description of the necessary
work to do in case the appliance has to be repaired. Please
refer to the after sales dealer policy for more information on the
repairing activities.
Make sure to follow all general safety instructions concerning
repairing electrical appliances.
Make sure to follow all specifi c safety instruction concerning this
appliance (see Chapter 1.1 of this manual).

5-1 CHANGE THE PROBE OF THE BOTTOM

RESISTOR
This is not possible by every technician! Only in Authorized
Repair Centres.
Switch off and disconnect the machine.
Unscrew the tilting box with the lid (item S30 articulation exploded
view and 47 in cover exploded view).
Return the appliance on its back and position it in the jig.
Remove the bottom plate (Item 27 on the housing exploded
view).
Remove the front panel (Item S11 on the housing exploded
view).
Remove the two lateral sides (Items 20 and 22on the housing
exploded view).
WHAT TO DO
- Increase the time of microwave (tw)
- If the time of microwave tw is more than the
total time (tt), increase also the total time (tt).
Decrease the time of microwave (tw)
Decrease the upper heating plate tempe-
rature (trt) and (or) decrease the total time
(tt).
Increase the upper heating plate tempe-
rature (trt) and (or) increase the total time
(tt).
Decrease the bottom glass temperature
(trb) and (or) decrease the total time (tt).
Increase the bottom glass temperature (trb)
and (or) increase the total time (tt).
21/38
warning :
- the temperature of the upper heating plate
is the same for the 4 programs.
- the temperature of the bottom glass is the
same for the 4 programs.
There are 2 ways to access the internal parts of the appliance:
by dismounting the bottom plate and by dismounting the back
panel of the tilting box.
In any case, do not open the appliance in total, i.e removing
both side panels at the same time. In doing so, all adjustments
of the appliance will be lost and the appliance is unusable. Only
the specifi c Authorized Repair Centres are able to make proper
adjustments with special tools.
Make sure to access the machine using the right way, which is
indicated in the following descriptions.
Disengage the two springs (Item 4 on the Launching Chamber
exploded view).
Remove the washers and the cylindrical spring (Items 5 and 6
on Launching Chamber exploded view).
Remove the launching chamber (item 9 launching chamber
exploded view).
Disconnect the probe cable in the board.
Take out the probe and replace with a new one.
Reassemble the appliance.
Warning! Remember to position and fi x the tilting box with the
core part of the appliance still in the jig (this will keep the correct
position between the lid and the working top).