Electrolux HSG Panini Service Manual page 22

Problem
Panino sticks to the upper plate
No
The panino is too much pressed
No
The upper plate is not remova-
ble for cleaning
No
HSPP tech GB 03 09
Panini is overcooked on the top
Yes
The Panino is partially or
completely sticking to the upper
plate
No
Yes
The Panino too much pressed
No
Yes
Upper plate not releasable
No
Check if ...
the resistor wiring 51 and 52 is
connected and not damaged (re-
sistor to terminal block and terminal
block to board)
The value of the resistance of the
probe is approximately 1,1KOhm at
room temperature (1,074 Kohm at
25°C/77°F)
the top heating element is absor-
bing current with the Multimeter
(approx. 4amps)
the board is providing the right vol-
tage : 208V for US version and 230V
for CE version
the top surface is cleaned (no
carbon deposits)
the right program was chosen
the programs have the right para-
meters
The value of the resistance of the
probe is approximately 1,1KOhm at
room temperature (1,074 Kohm at
25°C/77°F)
Yes: Check ...
the upper plate or the used baking
paper is clean
the upper plate or the used baking
paper is damaged
the programs have the right para-
meters (T<250°C)
the load (Panino) is appropriate to
the HSG
Yes: Check ...
the upper plate can adjust to the
Panino automatically (free move-
ment)
the Panino was placed correctly in
the work zone
the programs have the right para-
meters (time of MW)
the load (Panino) is appropriate to
the HSG
Yes: Check ...
the release pin is blocked, so no
pushing possible
the release pin can not be pushed
enough to release the plate
18/38
If not, action to do
reconnect or replace if damaged
replace the probe
replace it
replace it
clean it
use the right one
set the right parameters see the
brief cooking result trouble shooting
replace the probe
clean it
replace the baking paper or if neces-
sary the total upper plate kit
set the right parameters see the
brief cooking result trouble shooting
avoid this type of load
deblock the upper plate by cleaning
and/or repairing
train the user
set the right parameters
avoid this type of load
unblock the release pin
readjust or replace the release
system