Welcome & Congratulations Congratulations on your purchase of a new gas grill! At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. Your satisfaction is our number one priority.
General Safety Instructions IMPORTANT SAFETY INFORMATION - Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury. - Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED.
Grill Features: GL57 Roll top grill hood Grilling/Cooking surface Side Shelf Control knob: back infrared burner Control knobs: main burners Warming drawer Handle Warming shelf Infrared back burner Electronic ignitors: main, rear infrared & side burner Cart w/doors Drip Pans Side Burners Control knobs:side burner Control knob: bottom infrared...
Note: Prior to assembly remove protective film from stainless steel parts Assembly requires: 4 tools and a Friend Tools required: 1/4” socket wrench 1/2” socket wrench adjustable wrench scissors Ignitor Attachment Remove the ignitor cap, spring assembly, bat- tery and lock nut from ignitor. (See Fig. 1) Insert the threaded section of the ignitor into the U-shaped cut out of the ignitor mounting bracket.
Page 6
Side Shelf/Side Burner Assembly Side Shelves Attachment Loosen the bolts on the side of the grill and attach the shelf by allowing the bolt heads to fall through the large opening in the bottom of the keyhole slots. Then slide the shelves downward until the bolts are resting against the top of the key hole slots.
Page 7
Interior parts installation Check to make sure the bottom Flavor Grids are correctly installed in the cutouts and around the ignitors, as they may have shifted during shipment. (See Fig. 9) Insert the second row of Flavor Grids into cutouts with triangle ridges facing up. (See Fig.
Page 8
Built-In Instructions The Electrolux Grill can be installed as a built-in Grill. If installed as a built-in Grill, the Grill surround must be constructed of Non-combustible material. Planning and Design Start by identifying the number and size of components you want to include: Grill, side burner, access doors for storage or other items you may wish to furnish such as: refrigerator, sink, warming drawer.
Page 9
Side cutouts are needed on each side to feed ignitor wires to the ignitor plates and allow access to side gas connections (Size: 10” high x 5” long, set 1” back from front edge) GFI Electrical outlet for rotisserie motor (6.5 amp min.) *Required Ignitor cutout for front or side mount...
Gas Requirements General Information Verify the type of gas supply to be used, either Natural Gas (NG) or Liquid Propane (L.P)., and make sure the marking plate (located on the back of the unit) agrees with that of the supply. Note: Never attach an unregulated gas line to the appliance.
Page 11
L.P. Gas Installation Electrolux Gas Grills that are set to operate with L.P. gas come with a high capacity hose and regulator assembly. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Electrolux). This assembly is designed to connect directly to a standard 20 lb.
Leak Testing General Information Although all gas connections on the grill are leaked tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is detected.
Clearance to combustible construction - A minimum of 12” from the sides and back must be maintained from the gas grill above and below the cooking surface to adjacent vertical combustible construction. Clearance to non-combustible construction - A minimum of 3” clearance from the back of the grill to non-combustible construction is required for the lid to fully open.
Lighting the Grill Before Lighting Warning: Important! Before Lighting... Check the gas supply line for cuts, wear or abrasion. Always keep your face and body as far away from the grill as possible when lighting. Grill Burner Lighting This unit comes equipped with (2) electronic starters and (6) electrodes.
Page 15
Using the Rotisserie & Side Burner The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infrared type which provides intense searing radiant heat. Preferred by chefs over other cooking methods, this intense heat is magnificent for searing in the natural juices and nutrients found in quality cuts of meats.
Page 16
Using the Rotisserie & Side Burner Rotisserie Lighting Open the lid. Push and turn the control knob counter clockwise to the “HIGH” position. Wait 5 seconds. Then press and hold the electronic ignitor button. You’ll hear a snapping sound. If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes before trying again.
Care and Maintenance Drip Tray The drip tray located below the grill, inside the cart, should be cleaned periodically to prevent heavy buildup of debris. Note: Allow the drip tray to cool before attempting to clean. Cooking Grates The cooking grates can be cleaned immediately after cooking is completed and after turning off the flame.
Trouble Shooting General Trouble Shooting You should inspect the burners at least once a year or immediately if any of the following conditions occur: The smell of gas in conjunction with the burner flames appearing yellow. The Grill does not reach temperature. The burners make a popping noise.
Page 19
Problem Flame is erratic Flare-Ups Burner flame is yellow or orange, in conjunction with the odor of gas. Cart door does not align properly with cart Spider and Insect Warning Spider and insects can nest in the burners of this or any other Grill and cause the gas to flow from the front of the burner.
Warranty LIMITED LIFETIME WARRANTY Electrolux Grills have a Lifetime Warranty on all stainless steel panels, 15 years on stainless burners and a 5 year warranty on all other parts. IMPORTANT: We recommend you return the warranty registration card so that you can be contacted with any questions of safety arise that could affect you.