Electrolux HSG Panini Service Manual page 21

Problem
Panino is not grilled on
the bottom as desired
No
Panino is not grill on the top as
desired
No
Yes
Panini has no marks on
the bottom
No
Panini is overcooked on the
bottom
Yes
The Panino has no marks on
the top
No
Check if ...
magnetic detectors are working by
a continuity test from the connectors
14/15 (by closing the lid)
KS2 is working by visually checking
the light on when starting a cycle
switch breaker of the primary
transformer is on
if both magnetrons are working like
described in Err4or5
Yes: Check ...
The bottom resistor is working
(«orange color»)
the programs have the right para-
meters
the resistor wiring is connected and
not damaged
The value of the resistance of the
probe is approximately 1,1KOhm at
room temperature (1,074 Kohm at
25°C/77°F)
the board contact of connector 4
are supplying the right voltage :
208V for US version and 230V for
CE version
the probe is well in contact with the
glass
the bottom surface is cleaned (no
carbon deposits)
the right program was chosen
the programs have the right para-
meters
The value of the resistance of the
probe is approximately 1,1KOhm at
room temperature (1,074 Kohm at
25°C/77°F)
Yes: Check ...
the upper plate can adjust to the
Panino automatically (free move-
ment)
The upper plate is working
(measure temperature)
the programs have the right para-
meters concerning temperature
17/38
If not, action to do
readjust or change the magnetic
detectors
reconnect the wires or replace the
static relay
reactivate it
proceed like described under
Err4or5
proceed
set the right parameters see the
brief cooking result trouble shooting
reconnect or replace if damaged
replace the probe
replace the board
recondition/deblock the spring sys-
tem that hold the temperature probe
clean it
use the right one see the brief coo-
king result trouble shooting
set the right parameters
replace the probe
deblock the upper plate by cleaning
and/or repairing
proceed
set the right parameters see the
brief cooking result trouble shooting
HSPP tech GB 03 09