Acorp 4PM266M User Manual page 61

Table of Contents

Bhapter 1

2.12 Set Supervisor / User Password

◎ ◎ ◎ ◎ ◎ Figure 12. Set Supervisor / User Password

Standard CMOS Features

Advanced BIOS Features

Advanced Chipset Features

Integrated Peripherals

Power Management Setup

Enter Password:

PNP/PCI Configuration

PC Health Status

Esc : Quit F9 : Menu in BIOS

F10 : Save & Exit Setup

When you select this function, the following message will

appear at the center of the screen to assist you in creating a

password.

Type a password, up to eight characters, and press <Enter>.

The password you type now will clear any previously entered

password from CMOS memory. You will be asked to

confirm the password. Type the password again and press

<Enter>. You may also press <ESC> to abort the selection

and not enter a password. To disable the password, just press

<Enter> when you are prompted to enter a password. A

message will confirm that you wish to disable the password.

Once the password is disabled, the system will boot and you

can enter setup freely.

Frequency/Voltage Control

Load Fail-Safe Defaults

Load Optimized Defaults

Set Supervisor Password

Set User Password

Save & Exit Setup

Exit Without Saving

←→↑↓: Select Item

Time , Date , Hard Disk Type ...

Enter Password

1 - 2 8

BIOS Settp

Table of Contents