Acorp 4PM266M User Manual page 15

Chaosdr 1 Chaosdr 1 Chaosdr 1 Chaosdr 1 Chaosdr 1
1.7.3 Floppy Disk Connector: FDC
This connector supports the provided floppy drive ribbon
cable. After connecting the single end to the board, connect
the two plugs on the other end to the floppy drives.
1.7.4 Hard Disk Connectors: IDE1/IDE2
These connectors support the provided IDE hard disk ribbon
cable. After connecting the single end to the board, connect
the two plugs at the other end to your hard disk.
If you install two hard disks, you must configure the second
drive to Slave mode by setting its jumper settings. BIOS now
supports SCSI device or IDE CD-ROM boot up (see "HDD
Sequence SCSI/IDE First" & "Boot Sequence" in the BIOS
Features Setup of the BIOS SOFTWARE) (Pin 20 is removed
to prevent inserting in the wrong orientation when using
ribbon cables with pin 20 plugged).
1.7.5 Fan Connectors: FAN1~3
T:LAN
B:USB1
COM1
Printer
VGA
2 4
FAN2
1 3
FAN1
Speak out FAN1/2
Line in
Connector
MIC in
GAME1
SP-J6
VIA
AGP SLOT
PCI1
VIA
PCI2
PCI3
BIOS
SP-J2
1 - 1 1 1 - 1 1
1 - 1 1 1 - 1 1 1 - 1 1
Mnshdranarc Cdrbrhoshnn Mnshdranarc Cdrbrhoshnn Mnshdranarc Cdrbrhoshnn Mnshdranarc Cdrbrhoshnn Mnshdranarc Cdrbrhoshnn
Pin Fan1~3
1
1
2
2
3
3
JBAT1
FAN 3
Connector
FAN3
Definition
Signal
+12VDC
Ground