iBall Baton iB-WRT300N User Manual page 32

Click Advance, advanced selections for WAN Service Setup can be shown.
 MTU (bytes): Maximum Transmission Unit Size. Check this box then you can change the MTU
size. The default MTU value is 1500 Bytes. It is not recommended that you change the default
value unless required by your ISP.
 Enable NAT: This technology translates the IP addresses of a local area network to a different
IP address for the Internet. If this router is hosting your network's connection to the Internet,
please select the check box. If another Router exists in your network, you don't need to select
the option.
 Enable Fullcone NAT: It is a type of NAT, if not enabled, the default NAT will act.
 Enable SPI Firewall: A SPI firewall enhances network's security. Select the option to use a
firewall, or else without a firewall.
 Enable IGMP Proxy: IGMP (Internet Group Management Protocol) is used to manage
multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration for
client devices, such as the router. The default value is enabled, and if you are not sure,
please contact your ISP or just leave it.
iB-WRT300N 300M MIMO Triple Smart Router
Figure 3-6
26